Cobra Electronics MR HH425LI VP - Manual (Page 27)

Introduction
47 Nothing Comes Close to a Cobra ® 46 English
Introduction
Setup Mode Programming Setup Mode Programming
Voice Activated Transmit (VOX) Mode
In VOX mode, your radio can be used “hands-free,”
automatically transmitting when you speak. You can also set
the VOX sensitivity level to fit the volume of your voice and
avoid transmissions triggered by background noise.
To turn VOX Mode On or Off:
1. Display will show VOX icon and ON or OFF flashing.
2. Press Channel Up/Down button to select ON or
OFF.
3. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
To set VOX Sensitivity Level:
1. The display will show LE (level). VOX icon and 05
will be flashing.
NOTE
VOX sensitivity level is only visible when VOX is On.
2. Press Channel Up/Down button to change volume
level of your choice. Remember, this selection is
your voice sensitivity level during hands-free
operation.
05 - indicates a Low (quiet) voice setting.
03 - indicates a Medium voice setting.
01 - indicates a High (loud) voice setting.
3. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
NOTE
VOX will be turned Off automatically when the radio
is turned Off. This will avoid accidental transmissions.
NOTE
Once set, this is a global setting when in all radio
modes.
VibrAlert ® Mode
In VibrAlert ® mode, your radio can alert you to incoming
signals by sounding an audible call tone, a silent vibration or
both.
NOTE
VOX will be turned Off automatically when the radio
is turned Off. This will avoid accidental transmissions.
To set VibrAlert ® :
1. The display will show either the Vibrate icon (shake
bars), Call Tone icon (bell shape) or a combination
VibrAlert ® icon.
2. The present setting of either, 01, 02 or 03 will be
flashing.
3. Press Channel Up/Down button to select one of the
following:
01 = VibrAlert ® On (both shake bars and bell
shape).
02 = Vibrate On (shake bars only).
03 = Call Tone Only On (bell shape only).
4. Press Call/Enter/Setup button to save this entry and
move to the next setup programming mode.
NOTE
Once set, this is a global setting when in all radio
modes.
Operating Your Radio Operating Your Radio
VOX Mode
VOX Level
VibrAlert ® Tone Alert