Cobra Electronics MR HH425LI VP - Manual (Page 37)

67 Nothing Comes Close to a Cobra ®
Advanced Operation
66 English
Advanced Operation
Memory Locations
Your radio has unlimited memory locations for storing your
most frequently used channels. These memory locations can
be selected individually or can be scanned. (See page 69
under Memory Location Scan.) You are also able to change
bands for memory locations and scanning, allowing an
unlimited amount of choice selection.
To Program Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The Memory location number will start
flashing and the MEM icon will be turned On.
2. Use the Channel Up/Down button to advance to the
Memory location (00-99) you want to program.
3. Press the MEM/ESC button to select the Memory
location. The Memory channel number will stop
flashing and the channel number will start flashing.
4. Use the Channel Up/Down button to change to the
channel you want to store into the selected Memory
location.
5. Press the MEM/ESC button to program that channel.
The Memory location number will flash again.
Repeat steps 2 through 5 to program as many
additional memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to the Memory
mode.
7. Press and release the MEM/ESC button again to
return to the Marine or GMRS Standby mode.
Operating Your Radio
To Recall a Stored Memory Location:
1. Press the MEM/ESC button. The MEM icon will be
turned On.
2. Press the Channel Up/Down button to select the
memory location. If a memory location has been
programmed, its associated channel will display on
the LCD. Your radio is now in Marine or GMRS
Standby mode on the selected memory location.
NOTE
In addition to using the Channel Up/Down button
when selecting your memory channel, you can use
the BAND button to select channels in the GMRS
band.
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to the
Marine or GMRS Standby mode. The last channel used
in Marine or GMRS Standby mode will now be
displayed on the LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will start
flashing and the MEM icon will be turned On.
2. Use the Channel Up/Down button to advance to the
memory location you want to erase.
3. Press the MEM/ESC button to select the memory
location. The memory channel number will stop
flashing and the channel number will start flashing.
4. Use the Channel Up/Down button to change to the
channel to read “00” at the selected memory
location.
5. Press the MEM/ESC button to erase that channel.
Repeat steps 2 through 5 to erase as many additional
memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the MEM/ESC button again to
return to Marine or GMRS Standby mode.
Operating Your Radio
MEM/ESC Button
Memory Location Number
Channel Up/Down Button
Channel Number
MEM Icon
MEM/ESC Button
Memory Location Number
Channel Up/Down Button
Channel Number
MEM Icon