Cobra Electronics MR HH425LI VP - Manual (Page 38)

69 Nothing Comes Close to a Cobra ®
Advanced Operation
68 English
Advanced Operation
Channel Scan Mode
During Channel Scan mode, the radio will rapidly switch
from channel to channel through all the channels. Whenever
any activity is detected, the radio will stop the scan for 10
seconds to allow you to listen briefly on that channel. The
radio will then continue to scan unless you switch out of the
Channel Scan mode. The radio will perform normal
scanning operations from either Marine (VHF) mode or
GMRS mode, but it will only scan in that band.
NOTE
The radio must be squelched for the Channel Scan
mode to function. See page 40 for Squelch
procedure.
To Enter Channel Scan:
1. From Marine or GMRS Standby mode, press the
SCAN button. The radio will immediately begin to
scan the entire channel map selected in the active
channel map. The SCAN icon will show on the LCD.
2. A signal on any channel will stop the scan for 10
seconds to allow you to listen to the traffic on that
location.
NOTE
After the channel scan stops to monitor a channel, as
long as you do not press any buttons within 10
seconds, your radio will automatically resume
scanning the Channel Scan channels.
3. Press the Channel Up/Down button to resume
scanning the Channel Scan channels or to change
the scan direction.
4. To EXIT Channel Scan mode, press the SCAN
button again. The SCAN icon will disappear from the
LCD and the radio will return to Marine or GMRS
Standby mode.
Operating Your Radio
SCAN Button
SCAN Icon
Scanning Memory Location Scan
During Memory Location Scan mode, the radio will rapidly
scan through all pre-assigned memory channels. Whenever
any activity is detected on a channel, the radio will stop the
scan for 10 seconds to allow you to listen briefly on that
channel. It will then continue to scan unless you switch out
of Memory Location Scan mode.
NOTE
The radio must be squelched for the Memory
Location Scan mode to function. See page 40 for
Squelch procedure.
NOTE
If there are fewer than two (2) Memory locations
programmed in the radio, the Memory location scan
option will not be available. To program at least two
(2) memory locations, see page 66.
To Enter Memory Location Scan:
1. From Marine or GMRS Standby mode, press the
MEM/ESC button.
2. Press the SCAN button. The radio will immediately
begin to scan all pre-assigned memory channels.
The SCAN and MEM icons will show on the LCD.
3. A signal on any channel will stop the scan for 10
seconds to allow you to listen to the traffic on that
location.
NOTE
After the Memory Location Scan stops to monitor a
channel, as long as you do not press any buttons within
10 seconds, your radio will automatically resume
scanning the Memory Location Scan channels.
4. Press the Channel Up/Down button to resume
scanning the Memory Location Scan channels or to
change the scan direction.
5. To EXIT Memory Location Scan mode, press the
SCAN button again. The SCAN and MEM icons will
disappear from the LCD and the radio will return to
Marine or GMRS Standby mode.
A
A
Memory Location Scan
MEM/ESC Button
SCAN Button
Operating Your Radio
Channel Up/Down Button