Salter Brecknell 7620U - Manual (Page 23)

Model 7620U Bench Scale User’s Manual 23
Error Codes
H-100 Communications
Protocol
The “H” command is
to be used for non-
type approved
applications only.
7611 or NCI SMA
The H-100 communications protocol is the same
as NCI STD serial communications protocol with
the following exceptions:
The H<CR> command returns decimal weight at
100X the displayed resolution along with units
and scale status.
Contact your Weigh-Tronix service provider or
the Weigh-Tronix customer service department
for protocol.
Any system errors detected by the scale will be
displayed as the letter E followed by a two-digit
error code. Press the F1 key to continue opera-
tion. If a calibration error occurs, the only way to
clear it is by recalibrating the scale.
The error codes are broken down into two
hexadecimal numbers, with each bit defining a
single error condition. The error codes are
defined as follows: