BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 10)

Revised 10/22/2014 Page 10 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
49. Locate the temp sensor wiring (located in
rear of inner-cooler or in silicone air box) route
and plug into control box harness secure with
zip ties.
51. Install charge tube, (Inner-cooler and Air
Box) Adjust for maximum clearance and tighten
clamps 52.Install electronic boost solenoid using Velcro
and zip tie to secure to coolant hose. Route
3/16” line from brass fitting to top of solenoid .
53. Locate solenoid power connector from the
control box, follow stock wire harness over
steering linkage over to boost solenoid and plug
in secure with zip ties. 54. Route 3/16” line from 90 fitting on boost
solenoid to the boost actuator on turbo bracket.
NOTE: make sure to use small zip ties on ALL
3/16” hose connections to prevent blow off..