BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 8)

Revised 10/22/2014 Page 8 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
37. 38.Install machined throttle body adapters, make
sure o-ring is in throttle body groves tighten us-
ing supplied spanner wrench
NOTE: tighten un-
til compression ring bottom ,do not over tighten
39.Route fuel line from auxiliary injectors over
to fuel line bracket. Cut and splice into the fuel
line behind the bracket,
NOTE: splice into the
line that does NOT have in line filter.
40.Rotate the DET sensor as shown torque to
11- 12 ft lbs. Route wiring and zip tie to throttle
body coolant line.
41. Unplug the lower multi-pin connector from
the ECU, (located on backside of oil tank) Plug
the Boondocker wire harness in to ECU and
stock connector into Boondocker harness. 42. Route the Auxiliary injector connectors to
throttle body adapters and plug into Boondocker
injectors on fuel rails. Secure with zip ties