BoonDocker POLARIS: 2011-14 PRO RMK 800 Intercooled - Manual (Page 11)

Revised 10/22/2014 Page 11 of ?
www.boondockers.com………………..... ……….………………....877-522-7805
55. Install fittings on the waste gate as shown,
Top cap 1-vent and 1-plug . Below Diaphragm
1-pressure Fitting, and 2–plugs, and leave the
n2o ports empty. 56. Route 3/16” line from the 90 fitting on boost
solenoid to air fitting on external waste gate on
lower diaphragm .
57. At this time check all routing! Check all fuel
lines, wiring, and hose, make sure everything is
properly secured and zip tied to prevent rubbing
and chaffing! 58. Remove the stock air intake plenum from
under side of the hood.
NOTE : heat on the tabs
will help prevent breaking the tabs. Remove all
internal ducting.
59.Cut out the provided template and position on
plenum as shown. Template will follow plenum
mold. Trace the oval hole as shown. 60. Trim the oval hole out as shown