Detex 14DN Trim - Manual (Page 4)

DETEX INS-101296 Page 4
CHANGE LEVER HANDING
(Refer to Fig T12 on page 5)
A. Remove tailpiece extension assembly screw. (remove tailpiece extension assembly if necessary).
B. Remove the hex standoff and the two (2) screws holding the spring retaining plate.
C. WARNING: Springs under pressure! Remove spring retaining plate.
D. switch lock spring to opposite side (for 09 Function only).
E. Carefully remove the springs and bottom rack.
F. Remove the top rack.
G. Rotate lever to opposite side.
H. Engage the top rack on the opposite side as shown.
I. Engage the top rack on the opposite side as shown.
J. Install springs on the bottom rack.
K. Replace spring retaining plate and fasten the two (2) screws and the the standoff.
L. Replace tailpiece extension assembly and screw. Handing complete.