Detex AO19-1 Pull - Manual (Page 2)

Tools Required
1 - Knife 1 - 3/16” Drill bit 1 - Wire Stripper/Crimper
1 - Level 1 - ½ “ Drill bit 1 - Hacksaw
1 - Tape Measure 1 - 3/8” Drill Motor 2 - 18” Bar Clamps
1 - # 2 Phillips 1 - 3/8” Drill bit 1 - Set Allen Wrenches
1 - # 3 Phillips Bit 1 - Box 3/16” x 1 ¼” Tapcons 1 - Safety Glasses
1/4-20 or #14 Flat Head Screws 1 - Thin brush
General Conditions
The Detex Low Energy Automatic Door Operator is designed for Residential, Commercial and Industrial
use. If is to be retrofitted on to an existing door and frame, it is important that the door is in good condition
and swings freely, without restriction. It is also important that the header is sturdy and the operator must
be fastened securely using the appropriate fasteners.
WARNING: To reduce the risk of injuries to persons – use this operator only with a 250 lb. door(s) max.
All electrical wiring must comply with the National Electrical Code.
Not compatible with GFI (Ground Fault Interrupt) Breaker.
The Detex Low Energy Automatic Door Operator must be installed to comply with ANSI/BHMA A156.19
standards. It is not a solution to wind or stack air conditions. If these conditions exist, please call factory
for further information and possible solutions.
Beware that the door should: 1) open to at least 32” of clear opening; 2) have 5’ x 5’ of flat floor on both
sides; 3) be protected at bottom rail, 7 ½” up; 4) threshold must meet ADA Guidelines; and 5) a
commercial or residential swinging pedestrian door shall not close with a force greater than 15 lb. at the
latch side of the closing stile and shall not close through the final 10 degrees in less than 1.5 seconds.
104851 Page 2