Detex DTX-1300 - Manual (Page 3)

101160 Page 3
Follow steps 1-5 for all versions
1. Verify customer's specs and wiring according to Figure 2 or Figure 3 and power is on.
Note: If the anti-tamper switch (ATS) is wired to an alarm system, disable the alarm system
before proceeding to Step 2. (Re-arm alarm system when programming is completed.)
2 Open cover.
3. Turn "POWER" switch "OFF".
4. Turn "PROGRAM" switch to "OFF".
5. Turn "POWER" switch "ON" - solid green LED turns on.
MANUAL PROGRAMMING INSTRUCTIONS FOR DTX1000
6. Programming the "DTX1100" series with Keypad only:
COMMAND
set common access code (CAC)
set strike time
set door open time
set keypad time out
set supervisors code
disable supervisors code
(NOTE: Command 13 enabled, disables software functions)
set time
set date
7. Turn "POWER" switch "OFF".
8. Turn "PROGRAM" switch to "ON".
9. Turn "POWER" switch "ON" and observe LED flashes on/off.
10. Close cover and lock.
KEYPAD SEQUENCE
05 * 2 to 4 digits, 00-9999 #
08 * 3 digit No. 001-255 sec #
09 * 3 digit No. 001-255 sec #
10 * 3 digit No. 001-255 sec #
13 * 2 to 4 digits, 00-9999 #
13 * 0 #
17 * hr(00-23) * min(00-59) * sec(00-59) #
18 * mo(01-12) * day(01-31) * yr(00-99) #
6. Connect programmer to circuit board while holding cover firmly.
7. Programming the "DTX1200" series with Cardreader only using hand held PROGRAMMER:
COMMAND
validate range of cards
add one card to range of cards
cancel single card
reinstate all cancelled cards
set strike time
set door open time
print valid range of cards
print invalid card list
set time
set date
8. Turn "POWER" switch "OFF".
9. Remove hand held PROGRAMMER.
11. Turn "POWER" switch "ON" and observe LED flashes on/off.
12. Close cover and lock.
KEYPAD SEQUENCE
01 * start 4 digit(0001-9999) * end 4 digit(0001-9999) #
01 * start 4 digit * end 4 digit(include added card number) #
02 * 4 digit No.(0001-9999) #
02 * 0 #
08 * 3 digit No. 001-255 sec #
09 * 3 digit No. 001-255 sec #
11 * #
12 * #
17 * hr(00-23) * min(00-59) * sec(00-59) #
18 * mo(01-12) * day(01-31) * yr(00-99) #
10. Turn "PROGRAM” switch “ON”.