Dynojet WinPEP 7 - Manual (Page 74)

WinPEP 7 User Guide
C H A P T E R 6
Run Options
6-4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RUN OPTIONS
Run Options lets you further customize the MakeRun environment and provides tools
that can be used to simplify the MakeRun process.
1
Make sure you are in the MakeRun screen.
2 Verify you are connected to the dyno electronics. Refer to “Connecting the Dyno
Electronics” on page 3-11 for more information.
3 Click the MakeRun Configuration button .
4 Click the Run Options tab.
5 Enable or disable any of the Run Options. A description of the run options
follows.
6 Click OK when done.
Figure 6-8: MakeRun Configuration—Run Options
Graph Options—contains several options for configuring the graph.
• Max Runs Displayed — lets you specify the number of runs displayed on the
MakeRun graph.
• Graph Data Following Run — determines if the graph is displayed after the
run. If you do not want to view the graph, turn this option off.
• Hold Baseline — When this option is checked, the first run made will remain
the first in the list of runs on the MakeRun graph. It will remain the baseline
for the entire run session.