Dynojet WinPEP 7 - Manual (Page 81)

A D V A N C E D M A K E R U N F E A T U R E S
Expansion Systems
Version 2 WinPEP 7 User Guide
6-11
D YNOJET EXPANSION SYSTEMS
Advanced Breakout Board—Extended braking features can be configured through
use of the advanced breakout board. Appendix E provides more detail about
configuring the advanced breakout board.
Power Commander III USB—Collects data from a connected Power Commander III
USB. View channels available on the Power Commander III USB directly in the
MakeRun screen. Data is collected when a run is made and is available in the axis
selection list for graphing.
Note: The WinPEP software is unable to configure the Power Commander III
USB. Specific options in the connected power commander can only be configured
by using the Power Commander Control Center.
Wideband Commander—Collects data from a connected Dynojet Wideband
Commander. View channels available on the Dynojet Wideband Commander directly
in the MakeRun screen. Configure the analog 1 and analog 2 channels using the
Dynojet Wideband Commander software. Once the channels are configured, copy the
analog1.ana and analog2.ana files to your WinPEP directory. WinPEP will use these
files to configure the analog channels when viewed in WinPEP.
Note: The Wideband Commander selection will be disabled if you do not have an
Air/Fuel module added to your dyno electronics.
Dynojet Data Link Module (DJ-DLM)—Collects data from a connected Dynojet Data
Link Module. Configure the data channels using the configure button. The Prefix *H_
indicates data channels that are available from the Dynojet Data Link Module. See
Appendix F for more information.
S UPPORTED S YSTEMS
DiabloSport Predator—Collects data from a connected DiabloSport Predator. View
the selected PID’s in the MakeRun screen. Press the Configure button to select the
PID’s and configure the com port DiabloSport is using. Refer to Appendix G for more
detailed information.