EFCO Sliding Glass Door - Manual (Page 43)

EFCO CORPORATION 6/8/2012 PART NO. YW41 Page 43 of 59
SLIDING GLASS DOOR INSTALLATION INSTRUCTIONS
Locate 3203 and 11G3 jambs.
Adhere H068 head gaskets and H069 sill gaskets to the jambs.
Gaskets have a pressure sensitive adhesive on one side of the gasket. Match up the holes in the gasket
with the holes in the jambs and adhere to the jamb.
Locate the head and sill. Fasten the head and sill to the jambs with SLQ9 screws (#10 x 1 ¼” PL-PH-SMS
410 B-LP MG).
Anchor the doorframe into the opening.
For proper door operation, position the doorframe in the opening by using shims as needed to ensure that
the frame is plumb, square, and level without warp, twist, or bow.
Head
Jamb
Jamb
Sill
3179
Threshold
3150
3151
H069 Gasket
(Adhere to Jamb)
H068 Gasket
(Adhere to Jamb)
Interior
Exterior