EFCO Dorma RTS 88 - Manual (Page 13)

BAB 7/01
PAGE 11
D.
LOCATE THE C.O.C. COVER PLATE INTO THE HEADER/TRANSOM BAR CUTOUT AND
FASTEN THE COVER PLATE INTO PLACE WITH THE SUPPLIED SCREWS THAT WILL
THREAD INTO THE ’F’ CLIP.
A. BUTT HINGE, CONTINUOUS HINGE, CENTER PIVOTS
(CON’T)
1. CLOSER PREP AND INSTALLATION FOR 1 3/4" AND
2" HEADER/T’BAR
(CON’T)
SECTION III CLOSER PREPARATION AND
INSTALLATION
(CON’T)
DORMA RTS 88
OVERHEAD CLOSER
HINGE/
PIVOT
JAMB
#6-32x3/4" FHMS (C)
COVER PLATE TO ’F’ CLIP
2" HEADER/TRANSOM BAR (SHOWN)
COVER PLATES
{K492 PKG. MILL}
{K495 PKG. CLR}
{K496 PKG. BRZ}
E.
ATTACH THE DOOR STOP / SLIDE ARM COVER IN THE CORRECT LOCATION TO LINE
UP WITH THE DOOR STOPS AT THE JAMBS.
CAUTION!
DRILLING IN THIS AREA MAY DAMAGE THE CLOSER, THE
HEADER/T’BAR AND/OR C.O.C. THE COVER PLATE SHOULD
BE FULLY PREPPED FOR ANY ADDITIONAL HARDWARE
(SLIDE ARM COVER, HOLD-OPEN ARM, ETC.) BEFORE
INSTALLING THE CLOSER UNIT.