EFCO Dorma RTS 88 - Manual (Page 3)

BAH 8-9-04
PAGE 1
SECTION I PARTS IDENTIFICATION
SHEAR BLOCK w/ SCREWS
4" & 4 1/2" HEADER
(S402)
{K173}
SHEAR BLOCK w/ SCREWS
(S401 & S402)
{K120} - CLR. & BRZ.
ANGLE CLIP w/
OFFSET PIVOTS
{FT16}
ANGLE CLIP for
OFFSET PIVOTS
HQ42 (C)
"F" CLIP for BUTT
HINGES or GEARED
HINGES (C)
ANGLE BRACKET for
BUTT HINGES or
GEARED HINGES (C)
EFCO STANDARD C.O.C.
DORMA RTS 88 (C)
- ALL PARTS FOLLOWED BY (C) ARE INCLUDED IN THE CONCEALED OVERHEAD CLOSER PACKAGE.
- ALL PART NUMBERS ENCLOSED BY { } ARE SUPPLIED BY EFCO.
- SCREWS ARE LABELED AT DETAILS WITH EFCO PART NUMBERS ADDED.
CONCEALED OVERHEAD CLOSERS REQUIRE PRECISE ASSEMBLY TO FUNCTION
PROPERLY. CORRECT CLOSER APPLICATION MUST BE DETERMINED (CENTER
PIVOT, BUTT HINGE, GEARED HINGE OR OFFSET PIVOT) AND ASSEMBLY
FOLLOWED PER THESE INSTRUCTIONS. SOME OR ALL OF THE PARTS SHOWN
BELOW WILL BE REQUIRED FOR INSTALLATION OF THE C.O.C. PARTS
IDENTIFICATION: