EFCO Dorma RTS 88 - Manual (Page 16)

BAB 7/01
PAGE 14
DORMA RTS 88
OVERHEAD CLOSER
COVER PLATES
{K492 PKG. MILL}
{K495 PKG. CLR}
{K496 PKG. BRZ}
HINGE/
PIVOT
JAMB
4 1/2" HEADER/TRANSOM BAR (SHOWN)
#6-32x3/4" FHMS (C)
COVER PLATE TO ’F’ CLIP
A. BUTT HINGE, CONTINUOUS HINGE, AND CENTER PIVOTS
(CON’T)
2. CLOSER PREP AND INSTALLATION STEPS FOR 4" AND
4 1/2" HEADER/T’BAR
(CON’T)
SECTION III CLOSER PREPARATION AND
INSTALLATION
(CON’T)
E.
TIGHTEN THE FILLISTER HEAD SCREWS AND RECHECK TO MAKE SURE THAT ALL
SCREWS / NUTS ARE TIGHT.
F.
LOCATE THE C.O.C. COVER PLATE INTO THE HEADER/TRANSOM BAR CUTOUT AND
FASTEN THE COVER PLATE INTO PLACE WITH THE SUPPLIED SCREWS THAT WILL
THREAD INTO THE ’F’ CLIP.
4.
ATTACH THE DOOR STOP / SLIDE ARM COVER IN THE CORRECT LOCATION TO
LINE UP WITH THE DOOR STOPS AT THE JAMBS.
CAUTION!
DRILLING IN THIS AREA MAY DAMAGE THE CLOSER, THE
HEADER/T’BAR AND/OR C.O.C. THE COVER PLATE SHOULD
BE FULLY PREPPED FOR ANY ADDITIONAL HARDWARE
(SLIDE ARM COVER, HOLD-OPEN ARM, ETC.) BEFORE
INSTALLING THE CLOSER UNIT.