EFCO Dorma RTS 88 - Manual (Page 18)

BAB 7/01
PAGE 16
NOTE:
THE FINISH ON THE ATTACHMENT SCREWS SHOULD MATCH THE FRAME’S FINISH.
#12-24X3/4"PL-FH-MS 18-8 UC
- SEE NOTE BELOW -
{M100 - CLR}
{M108 - BRZ}
#10-32X5/8"
PL-FH-MS 18-8
- SEE NOTE BELOW -
{M130 - CLR}
{M131 - BRZ}
ANGLE CLIP
HQ42 (C)
DORMA RTS 88
OVERHEAD CLOSER
SPACER {F045}
ANGLE CLIP {FT16}
2" HEADER/TRANSOM BAR (SHOWN)
HINGE/
PIVOT
JAMB
C.
INSERT THE CLOSER, WITH THE ANGLE CLIP AND THE SPACER BLOCK
ATTACHED (402 ONLY), INTO THE TRANSOM BAR. LOCATE THE SPACER BLOCK
OVER THE PREPPED HOLES IN THE TRANSOM BAR AND ATTACH WITH TWO
#12-24X3/4" FH-MS.
D.
SECURE THE CLOSER IN PLACE WITH TWO #10-32X5/8" FH-MS INTO THE
ANGLE CLIP AT THE OPPOSITE END.
B. OFFSET PIVOTS
(CON’T)
1. CLOSER PREPARATION AND INSTALLATION STEPS
SECTION III CLOSER PREPARATION AND
INSTALLATION
(CON’T)