ETS-Lindgren SMART 1000 Mini-Reverb Cell - Manual (Page 22)

22 | Tuners
• Mount bearing inner and outer plate.
• Using a lift, raise the tuner into position and align the shaft ends. Fix
the couplers without the key to the motor shaft end and bearing end if
a separate shaft is used. Alternatively, insert the tuner end shaft into
the idler bearing and secure with the fixing (set/grub) screws.
• For the vertical tuner, locate the tuner shaft in the ceiling clamp to
temporarily support the weight of the tuner.
• Locate and fix the idler bearing to the floor using wood screws supplied
for modular panels (S81) or bolts to the inner floor of the pan-type
room.
• Secure the tuner shaft in the idler bearing with at lease 1/2-in (12-mm)
gap between the shaft and chamber surface. Secure the set screw so
that tuner weight can be taken by the bearing.
• Release the motor coupling and insert the key into the keyway. Tighten
coupling.