ETS-Lindgren 7000-001 EMCenter Modular RF Platform - Manual (Page 31)

www.ets-lindgren.com Manual Control of the EMCenter 31
Configuration Screen
Press Config to display the Configuration screen. The IEEE address of the
EMCenter can be changed here.
Sample Configuration Screen
 IEEE Board —Press Change to enable or disable the board
(if installed).
 IEEE Address —Press Up or Down to change the address
(if installed).
 IP Address —Press Change to set a new address.
 Gateway Address —Press Change to set a new address.
 Touchscreen Calibration —Press Calibrate Screen and follow the
on-screen instructions.
 Laser Protection Code —Press Change to enter or change a code.