ETS-Lindgren 7000-001 EMCenter Modular RF Platform - Manual (Page 34)

34 Remote Control of the EMCenter www.ets-lindgren.com
Second Character: Device ID Number
Each card in the EMCenter is assigned a unique device ID number that is the
same as the slot number; all commands for plug-in cards must be preceded by
the numbered slot where the card is installed. Additionally, if the card provides a
multiple port, like EMPower, the port number must also precede the command. A
carriage return (CR) must terminate each command.
Looking at the back of the EMCenter, the card slots are numbered
1 to 7 from left to right.
For example, if the EMCenter was installed with the following cards, you would
configure the device drivers of the external software with the device ID numbers
shown in the table.
Card Slot Number
=Device ID Number
Port Number Plug-in Card Type
1 EMSwitch
2 EMLink
3 EMPower
3 A EMPower
3 B EMPower
3 C EMPower
4 D EMPower
5 EMSense
6 Empty
7 Empty
8 Processor
9 Power Supply