ETS-Lindgren HI-4416 Numeric EMF Readout Unit - Manual (Page 16)

16 Pre-Installation Tasks www.ets-lindgren.com
5. Press the ON/OFF keypad on the front panel of the HI-4416. All
segments of the LCD will activate for two seconds, then the version of
software installed in the HI-4416 will be displayed followed by the
current range of the probe connected to the readout. The HI-4416 will
then begin normal operation. Units of measure, current reading (if any),
bar graph, etc., will be displayed. If, after several seconds, the readout
indicates an error condition, see Appendix: B: Error Codes for
additional information.