Gastroback 42606 Design Espresso Plus User Manual

Page 17

Advertising

frothing milk

wARninG:

Hot steam or hot water escape from the steam wand. Never place your hands

or other body parts under the steam wand, or less if the selector switch is on the steam or hot

water position. Place a suitable container under the steam wand before you turn the selector

switch into the steam or hot water position.
1.

Make sure that there is sufficient water in the water tank (between

the MIN and MAX marks).
2.

Press the ›on/off‹-switch and turn on the appliance.

Turn the black folding switch to the steam position.

Fill the stainless steel frothing jug about

with fresh cold milk.

note:

The best results are obtained with reduced-fat fresh milk.

Turn the selector switch to the left into the ›steam‹-position. The heating

indicator lights up. The thermoblock is heated to produce steam. The pro-

cess takes about 30 seconds. Swirl the tip of the steam wand over the drip

tray. When only steam and no water droplets are coming out of the steam

wand, turn the selector switch to the middle into the standby position.
note: Initially a few drops of water may emerge from the steam wand. For this reason, the

steam wand should be directed initially to the drip tray. The remaining water that is in the

system is thus flushed out of the steam wand.
6.

Now hold the milk frothing jug under the steam wand and immerse the tip of the steam

wand approximately 10 mm into the milk. Now turn the selector switch back counterclockwise

to the ›steam‹-position. Water steam escapes from the steam waned and the frothingstarts.
note:

If steam is already leaking from the steam wand and the steam wand is not immersed

into the milk, then the escaping steam could spray the milk from the frothing jug.
7.

Hold the attachment for frothing to the edge of the frothing jug. Through the escaping

steam, the milk moves in a circle through the cup.
note:

During the steaming process, the steam indicatior lights up. The thermoblock is hea-

ted to maintain a constant temperature and continue to steam production.
wARninG:

From the steam wand and the attachment hot steam escapes, and these com-

ponents are very hot. Always be sure not to scald at the hot steam. Never touch the steam

wand during steam generation. Hold the steam wand during operation cautiously by the

attachment. Be careful not to scald yourself.
note:

You can swivel the steam wand as desired in order to work comfortably. Hold the

steam wand only by the dark attachment.
8.

If the volume of the milk increases in the frothing jug, hold the attachment a little deeper

into the milk to heat the milk well. Hold the frothing jug with one hand on the handle.
ATTenTiOn: The frothing jug bottom and the frothing jug can be very hot due to the steam.
important:

Make sure that the milk does not run over the top of the attachment. Otherwise,

the appliance will not work properly.
wARninG: Never remove the steam wand from the milk, as long as steam is escaping.

Otherwise, hot milk splash out of the frothing jug. Turn the selector switch always first to

Steam

Advertising