Gastroback 42606 Design Espresso Plus User Manual
Page 21
Cleaning the Steam wand
Clean the steam wand each time after you have frothed milk, otherwise protein and fat
in the milk will form a solid crust, through which the steam wand and the openings in the
attachment are clogged.
1.
Make sure first that the appliance is in the standby position (the selector switch is in the
middle) and the steam wand and the attachment are no longer hot.
2.
Remove the attachment from the steam wand and rinse the attachment in warm water.
3.
Wipe the steam wand with a damp cloth. Swing then the steam wand over the drip tray
and remove your hand from the steam wand.
4.
Rotate the selector switch counterclockwise to the steam position. The milk residues will
be rinsed from the inside of the steam wand.
5.
Turn the selector switch clockwise back to the standby position. Press
the ›on/off‹-switch and turn the appliance off. Unplug the power cord
and allow the appliance to cool.
6.
If the steam wand is clogged with deposits, then pierce the steam
wand with the needle in the cleaning tool.
7.
If the the clogging will not dissolve, then unscrew the tip of the steam
wand.
8.
Soak the steam wand tip for about 10 minutes in a hot detergent solution and then open
the hole in the steam wand tip with the needle in the cleaning tool. Be careful not to pierce
yourself with the needle.
9.
Screw the steam wand tip back onto the steam wand.
ATTenTiOn: Do not apply any violence when screwing the steam wand tip on, so as
not to strip the threads. The steam wand tip must be tightened only slightly, so that no gap
between the steam wand tube and the steam wand tip remains.
10.
Insert the attachment with the narrow end onto the steam wand and push up until it clicks
into place. The attachment should not wobble or fall off. Rotate the attachment during the
process slightly back and forth.
note:
The attachment has two resistors inside and is placed properly, when you have
pushed the attachment for snapping up over the first resistance onto the steam wand. The
steam wand should be located only in the narrow part of the attachment and must not
protrude from the top down.
Cleaning the filters, the portafilter and the Gouphead
1.
Rinse the used filters and the portafilter immediately after each use with clean water.
Remove all remains of coffee powder. If the pores in the filter are clogged, use the needle
in the cleaning tool to open the pores.
2.
Wipe the inside of the grouphead with a damp cloth to remove the remains of the coffee
powder.
3.
Rinse the portafilter and the grouphead by regularly. To do this, insert the portafilter with
one of the filters (without coffee!) into the appliance and let some water to flush through and
remove all remnants of the coffee powder from the pores.
51
Attach-
ment
Steam
wand