Gastroback 41006 Design Mixer Advanced Pro - Manual (Page 7)

45
• Operate the appliance on a well accessible, stable, level, dry, and suitable large surface.
Do not place the appliance or any part of it on or near hot surfaces (heater, gas burner, grill,
or oven). Do not place the appliance near the edge of the table or counter or on inclined
or wet surfaces or where it can fall. Keep the entire appliance away from direct sunlight and
sharp edges. Ensure the blender jug is locked securely onto the motorblock and that you can
not knock the appliance over during operation to avoid personal injury. Do not place the
appliance on a metal surfaces for example, a sink drain board.
• Never leave the appliance unattended when the plug is connected to the power outlet. Always
immeDiATeLy turn the appliance ›Off‹, wait for the motor to stop completely, and then unplug
the appliance, if the appliance is not in use (even for a short break) and before assembling,
disassembling or cleaning. Never leave the appliance unattended when in operational mode.
• Do not leave any food dry on the surfaces of the appliance. Do not immerse the motor
housing or power cord in water or any other liquid. Do not pour or drip any liquids on the
motor housing or power cord. When liquids are spilled on the motor housing, immediately
unplug the appliance and dry the motor housing to avoid risk of electric shock or fire. Do
not attempt to operate the appliance, when liquids are on or in the motor housing.
• Do not place the motorblock in an automatic dishwasher!
• To avoid damage, do not use any abrasive cleaners, corrosive chemicals (i.e. disinfect-
ants, bleach) or cleaning pads for operation or cleaning. Do not use any hard or sharp
utensils for operation or cleaning. Always handle the entire appliance and all parts of it with
care and without violence.
•
wARning:
The blades are very sharp. Pay attention when handling the blades. Only
touch the blades on the blade assembly housing and handle with care when cleaning.
• Do not use the appliance if it is damaged or units of the appliance are damaged. Do not
use the appliance if it does not function properly or if it was excessively loaded. The appliance
is likely damaged if the appliance or units of the appliance show cracks, exorbitant wearing
down, alterations or leaks. It is also likely damaged if the drive wheel of the motorblock moves
slowly. Take the appliance for technical maintenance and repair to an authorised specialised
reparation shop.
• Do not operate the appliance without food or liquids in the blender jug.
•
wARning: Do not overfill the blender jug to avoid overrunning, spurt out. If necessary,
take some food out of the blender jug, using a wooden or plastic spoon, before starting the
appliance again.
• In the unlikely event of an excessive load or if the motor stalls or stucks turn ›Off‹ the appli-
ance (all buttons are deactivated) to avoid overheating and let the motor rest for 10 seconds
to cool down before continuing to operate.
• Do not chop extremely hard food, such as nuts with shell, bones to avoid overrunning,
spurt out or that the motor stalls or stucks during operation because the blade is blocked.
•
wARning: Do not fill ingredients into the blender jug which exceed a temperature of
60 degrees. After processing ice cubes slowly heat up the blender jug before processing hot
ingredients. Otherwise the blender jug will crack or get damaged. Use gloves processing hot
liquids and do not fill the blender jug up too high. Ensure not to burn yourself on the blender
jug, on overrunning, spurt out or hot steam. Touch the handle only for lifting the blender jug.
When processing hot food take out the inner lid to let out the hot steam and to avoid pressure
build-up. Place a towel over the opening in the lid to avoid splatter.
• The appliance is for household only.