Gastroback 41006 Design Mixer Advanced Pro - Manual (Page 8)

46 47
movable and sharp-edged parts – risk of injury
• Do not remove the blender jug from the motorblock whilst in operation. Always turn the
appliance ´Off` (all buttons are deactivated), wait for the motor to stop moving and then pull
the plug before removing the blender jug from the motorblock or taking off the lid. It could
take about 3 seconds until the motor has completely stopped. Never leave the appliance ›On‹
when not in use.
• never put your hands, wooden spoons or other foreign substance (such as hair, cloth,
brush, towels) into the blender jug when the motor is running or the appliance is connected to
the power outlet. Always take the blender jug off the motorblock first before you push down
the food with a spoon or add new ingredients.
•
wARning: The blades are very sharp. Pay attention when handling the units. Only
touch the blade assembly housing when handling the blades. Handle with care when clean-
ing. Only store the appliance completely assembled. This way the blades will be out of reach.
• note: Ensure the appliance is properly assembled and that the blade is properly attached
before putting the plug into the power outlet. Do not operate the appliance without the lid or
the inner lid. Never place only the jug or the blade assembly housing only on the motorblock.
Never touch the drive gear when the plug is connected to the power outlet.
• Always keep one hand on the lid while processing.
•
wARning: If the blade is mounted to the blender jug, the blender jug is positioned on
the motorblock, and the plug is connected to the power outlet, do not insert your fingers, a
wooden or plastic spoon or similar cooking utensils or foreign substances in the blender jug.
Always take the blender jug off the motorblock before pushing the food down. Use a spatula
to dislodge or stir the food before continuing. Do not use fingers as the blades are sharp.
important safeguards for all electrical appliances
• Always operate the appliance near a suitable wall power outlet and connect the appliance
directly to the power outlet. Do not use any extension cords or a multiple desk outlet.
• Ensure that the voltage rating of your mains power supply corresponds to the voltage
requirements of the appliance (230/240 V, 50 Hz, AC). Always connect the appliance direct-
ly to a mains power supply wall socket with protective conductor (earth/ground) connected
properly. The installation of a residual current safety switch with a maximum rated residual
operating current of 30 mA in the supplying electrical circuit is strongly recommended. If in
doubt, contact your local electrician for further information.
• Do not leave the appliance unattended when connected to the power supply. Always turn
the appliance ´Off` (all buttons are deactivated) and immediately unplug the appliance after
operation and if it is not in use (even for a short break) and before cleaning and/or assem-
bling or disassembling. Always grasp the plug to disconnect the appliance from the power
outlet.
• Fully unwind the cord before use. Always handle the power cord with care. Do not pull
or strain the power cord. The power cord may never be knotted or squeezed. Do not let
the power cord hang over the edge of the table or counter. Take care not to entangle in the
power cord. Do not touch the appliance with wet hands to avoid risk of electric shock. Do
not
touch the appliance, if it is damp or wet or is touching wet surfaces while connected to
the mains power supply. In this case, immediately unplug the appliance and dry the appliance
(see ›Care and cleaning‹).