General Hydroponics PowerGrower 8-Pack - Manual (Page 2)

POWERGROWER 8-PACK PARTS ASSEMBLY
STEP 1
Disassemble the Float Valve
(part 5) and insert the threaded
end with the washer on the
inside of the Controller (part 1),
through the predrilled hole in
the Controller and secure from
the outside with the nut. Coat
the remaining threads with the
Pipe Thread Compound and
screw on the brass 1/2” barbed
hose fitting.
POWERGROWER 8-PACK PARTS:
1: Reservoir & Controller (2)
2: Reservoir & Controller Lid (2)
3: Hatch Cover (2)
4: Reservoir & Controller Connecting Hose
5: Float Valve with pipe thread compound
6: Controller Drain Level Tube
7: Circulating Pump Column with Collar
8: Circulating Pump Connector with Split Tee
9: Drip Rings (8)
10: Clear Airline (8)
11: Pumping Columns with Support Tubes (8)
12: Individual Drain Level Tube with 1” grommet reducer
13: Blue Tubing (20 ft.)
14: Split Tees (8)
15: Single Output Air Pump
16: Individual Reservoir (8)
17: Growing Chamber (8)
18: Dual Diaphragm Air Pump
18 1
2
3
4 6 7 5 9 10 11 12 13 14
17 16
8
15
Pipe Thread Compound