General Hydroponics PowerGrower 8-Pack - Manual (Page 5)

ASSEMBLY ASSEMBLY
STEP 13
Securely attach the
Clear Airlines (part 10)
to the flexible tubing
of the Pumping Column
Assemblies.
STEP 14
Connect the manifold to the Dual Diaphragm Air Pump (part 18) and connect the
airline tees (that are packaged with the Dual Diaphragm Air Pump) to the manifold.
If you choose the compact honeycomb configuration, connect the Clear Airlines from
the 7 growing units to the tees and connect a Clear Airline to the Black Airline from
the circulating pump. Otherwise, connect the Air Lines from the 8 growing units and
connect the circulating pump to the Single Output Air Pump (part 15).
STEP 12
To setup the individual growing units in a compact honeycomb pattern, arrange
the controller assembly and the individual growing units according to the following
diagram. Cut the Blue Tubing (part 13) into eight 20” long pieces, and connect the
individual units to each other and the controller assembly.
The individual units can also be arranged in two rows or any other custom config-
uration. Place the individual growing units according to the following diagram or
your own custom configuration and cut the Blue Tubing (part 13) to custom lengths
to connect the individual growing units to each other and the controller assembly.
STEP 15
If you only used 7 of the growing units in the circulating system, remove the
1” Grommet Reducer that is connected to the Individual Drain Level Tube (part 12)
and insert the 1” Grommet Reducer into the 1” grommet of the left over Individual
Reservoir (part 16). Insert the Individual Drain Level Tube into the 1/2” opening of the
1” Grommet Reducer and complete the stand alone unit just as the other units used in
the circulating system. After completed, connect the Single Output Air Pump (part 15)
to the flexible tubing of the pumping column assembly.