General Hydroponics PowerGrower 8-Pack - Manual (Page 3)

ASSEMBLY ASSEMBLY
STEP 3
Insert the Circulating Pump Column (part 7) into the tabs on the bottom of the Controller
(part 1) and push the collar down over the tabs. Insert the Y-fitting from the Circulating
Pump Column into the elbow from the Circulating Pump Connector (part 8)
STEP 4
Make sure the black airline is securely inserted into the Y-fitting and thread the other
end thru the cap in the Controller Lid (part 2). Place one of the Hatch Covers (part 3)
over the access hole in the Controller Lid
STEP 5
Place the Reservoir (part 1) on top of the assembled Controller. Connect the Reservoir
to the Controller by inserting the 1/2” straight barbed fitting of the Connecting Hose
(part 4) into the 1/2” grommet on the Reservoir and connect the other end of the blue
tubing to the brass barbed fitting of the float valve. Place the Reservoir Lid (part 2) with
the Hatch Cover (part 3) on the Reservoir.
STEP 2
Insert the Drain Level Tube (part 6) into the 1/2” grommet on the side with the support
tab. Insert Circulating Pump Connector with Split Tee (part 8) into the 1” grommet
opposite the Drain Level Tube and support the grommet from the backside while
securing the Split Tee into the grommet.