Hybrid Racing HR 06+ 8th Gen Civic Si Shifter Cables - Manual (Page 5)

5
OEM Cable Removal
STEP 6:
Next you will need to use your 8mm nut driver to remove the (4) bolts that hold the center
console down. The front (2) are right in front of the shifter as seen in Fig 6A, and to get to
the rear (2) you must open the center console compartment and remove the rubber mat to
get to them as seen in Fig 6B. Next you will need your flathead screwdriver again to re-
move the two plastic push-pin clips in the very front. The one on the left side is right next to
the gas pedal(Fig 6C). To get to the right one you will need to pull the plastic piece under
the glove box off by pulling straight down. This will reveal the right side clip as seen in Fig
6D.
STEP 5:
For the next set of steps , we will move
into the interior of the car. Start by pull-
ing the emergency brake up and un-
screwing the shift knob. Next, pull the
shift boot off by pulling straight up on all
four corners of the plastic base. Then
remove the upper center console piece
by grabbing right under the shifter and
pulling straight up(Fig 5).
Fig 5
Fig 6A
Fig 6B
Fig 6C Fig 6D