Ipmi setup, 1 ipmi in a compactpci chassis, 2 ipmi setup for the cp6003-sa/ra/rc – Kontron CP6003-RC IPMI User Manual
Page 12: Ipmi in a compactpci chassis, Ipmi setup for the cp6003-sa/ra/rc, Ipmi firmware cp6003-sa/ra/rc
IPMI Firmware
CP6003-SA/RA/RC
Page 12
ID 1045-5656, Rev. 2.0
P R E L I M I N A R Y
2.
IPMI Setup
2.1
IPMI in a CompactPCI Chassis
Kontron's IPMI implementation in the CompactPCI environment is compliant with the PICMG
2.9 R1.0 specification. This specification defines the pinout of the J1 and J2 CompactPCI con-
nectors as well as the addressing scheme. There should be only one BMC in the chassis, or at
least on the IPMB segment. The BMC may reside either on an CP6003-SA/RA/RC, or on an
external system management card, or in a shelf management controller (ShMC). The specifi-
cation allows all of these variants. As a BMC in the system slot, the CP6003-SA/RA/RC sup-
ports dual-ported IPMB (IPMB-0 to the SMCs and IPMB-1 to the external segments via the
CompactPCI backplane connector in accordance with PICMG 2.9).
To use the IPMI resources in a rack requires an initial setup for IPMI operation. The following
actions must first be performed to achieve operable IPMI functionality.
2.2
IPMI Setup for the CP6003-SA/RA/RC
Initially the default configuration for the IPMI controller of the CP6003-SA/RA/RC is:
•
IRQ = none
•
MODE = SMC
•
IPMB = single-ported.
If this is the required configuration, no further action is required. If the configuration must be
modified, either the kipmi uEFI Shell command or one of the open tools “ipmitool” or “ipmicmd”
may be used to modify the configuration as required.
BMC
IPMB
Address
Fix: 20h
Backplane
SMC
IPMB
Address:
B0h
(1)
SMC
IPMB
Address:
B2h
(1)
SMC
IPMB
Address:
B4h
(1)
SMC
IPMB address for SMC is determined via the location of the slot in the chassis
IPMB
Address:
B6h
SMC
IPMB
Address:
B8h
(1)
(1)
SMC
IPMB
Address:
BAh
(1)
SMC
IPMB
Address:
BCh
(1)
IPMB 0
IPMB 0
(1)
IPMB 1