Os support / tools, 1 linux tools, 2 os support - board support packages – Kontron CP6003-RC IPMI User Manual
Page 43: Cp6003-sa/ra/rc ipmi firmware
CP6003-SA/RA/RC
IPMI Firmware
ID 1045-5656, Rev. 2.0
Page 43
P R E L I M I N A R Y
The parameters for the IPMI controller's serial interface can be set by using the following com-
mand:
This command shows all options that can be set.
Further options are listed after issuing the following command:
14.
OS Support / Tools
14.1
Linux Tools
OpenIPMI - KCS driver
Normally all drivers and kernel modules needed for communication between the payload sided
software and the IPMI firmware via the KCS interface come with the distribution. Newest sourc-
es can be downloaded from: “http://openipmi.sourceforge.net”. There may be downloaded the
OpenIPMI project as well. The OpenIPMI library package includes some applications and the
needed libraries.
ipmitool
Another very useful all-in-one tool is “ipmitool” (http://ipmitool.sourceforge.net ). It provides a
user-friendly interface to many IPMI features and extensions, for example, to get sensor read-
ings, change sensor thresholds or to access other IPMI controllers via IPMB. Before “ipmitool”
can be used the OpenIPMI driver, mentioned above, must be loaded too.
14.2
OS Support - Board Support Packages
For information on the operating systems supported with the CP6003-SA/RA/RC, please refer
to the CP6003-SA/RA/RC’s data sheet. Please visit “http://www.kontron.com” to download the
data sheet. Please also have a look at the download section for the latest versions of Board
Support Packages or Firmware Updates.
For further information concerning IPMI, refer to the BSP documentation for the respective OS.
ipmitool sol set
ipmitool sol help