Kontron CP6003-RC IPMI - Manual (Page 41)

CP6003-SA/RA/RC IPMI Firmware
ID 1045-5656, Rev. 2.0 Page 41
P R E L I M I N A R Y
13.3 Basic Setup from uEFI Shell
With the kipmi net command from uEFI Shell some basic settings such as IP address, sub-net
mask and gateway address can be set up for all of the four Ethernet channels.
13.4 Setup by “ipmitool” or IPMI Commands
The open tool “ipmitool” offers commands for the setup of the four Ethernet channels. All pos-
sible options are shown by issuing:
If “ipmitool” is not usable, the LAN parameters can be set by using standard IPMI commands
as defined in the IPMI specification.
To show the current LAN parameters for a channel, “ipmitool” offers the command:
13.5 Setup of User Accounts and Password
The open tool “ipmitool” offers commands for the listing and manipulation of user accounts for
channels 1 through 4. An overview can be obtained by issuing:
The predefined user accounts for a channel can be listed using the following command:
For every channel, the CP6003-SA/RA/RC has these predefinitions in non-volatile memory:
Please note that the ADMINISTRATOR password is preset with admin.
Changed accounts and passwords stay valid after payload power-off.
The accounts must be activated using the following command:
ipmitool lan set
ipmitool lan print <channel = 2, 3, 4, 5>
ipmitool user
ipmitool user list <channel = 2, 3, 4, 5>
ID Name Callin Link Auth IPMI Msg Channel Priv Limit
1 false true true USER
2 admin false true true ADMINISTRATOR
ipmitool user enable <user number>