Kontron AT8902 Full Size CLI - Manual (Page 150)

AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 3 - 38
Metric Shows the metric for the advertised default routes. If the metric is not
configured, this field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths Shows the maximum number of paths that OSPF can report for a
given destination.
Redistributing This field is a heading and appears only if you configure the system to
take routes learned from a non-OSPF source and advertise them to its
peers.
Source Shows source protocol/routes that are being redistributed. Possible
values are static, connected or RIP.
Metric Shows the metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag
Shows the decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the
specified protocol.
Distribute-List Shows the access list used to filter redistributed routes.
3.7.42 show ip ospf area
This command displays information about the area. The <
areaid
> identifies the OSPF
area that is being displayed.
Format show ip ospf area <areaid>
Modes Privileged EXEC
User EXEC
AreaID Is the area id of the requested OSPF area.
External Routing Is a number representing the external routing capabilities for this
area.
Spf Runs Is the number of times that the intra-area route table has been calcu-
lated using this area's link-state database.
Area Border Router Count The total number of area border routers reachable within
this area.
Area LSA Count Total number of link-state advertisements in this area's link-state
database, excluding AS External LSA's.
Area LSA Checksum A number representing the Area LSA Checksum for the speci-
fied AreaID excluding the external (LS type 5) link-state advertise-
ments.
Import Summary LSAs Shows whether to import summary LSAs.
OSPF Stub Metric Value Shows the metric value of the stub area. This field displays
only if the area is a configured as a stub area.
The following OSPF NSSA specific information displays only if the area is configured
as an NSSA.
Import Summary LSAs Shows whether to import summary LSAs into the NSSA.