Kontron AT8902 Full Size CLI - Manual (Page 253)

AT8901/2/3 Management Commands
Page 6 - 13 AT8901/2/3 CLI Reference Manual
NOTE: You cannot delete the admin user, and there is only one user allowed
with read/write privileges. You can configure up to five read-only
users on the system.
6.5.1 users name
This command adds a new user account, if space permits. The account
<username>
can
be up to eight characters in length. You can use alphanumeric characters as well as the
dash (‘-’) and underscore (‘_’). You can define up to six user names.
NOTE: The <username> is not case sensitive when you add and delete users,
and when the user logs in. However, when you use the
<username>
to
set the user password, authentication, or encryption, you must enter
the
<username>
in the same case you used when you added the user.
To see the case of the
<username>
, enter the
show users
command.
Format
users name <username>
Mode Global Config
6.5.1.1 no users name
This command removes a user account.
Format
no users name <username>
Mode Global Config
NOTE: You cannot delete the “admin” user account.
6.5.2 users passwd
Use this command to change a password. Passwords are a maximum of eight
alphanumeric characters. If a user is authorized for authentication or encryption is
enabled, the password length must be at least eight alphanumeric characters. The
password is case sensitive. When you change a password, a prompt asks for the old
password. If there is no password, press enter. You must enter the
<username>
in the
same case you used when you added the user. To see the case of the
<username>
, enter
the
show users
command.
Default no password
Format
users passwd <username>
Mode Global Config
6.5.2.1 no users passwd
This command sets the password of an existing user to blank. When you change a
password, a prompt asks for the old password. If there is no password, press enter.
Format
no users passwd <username>
Mode Global Config