Kontron AT8902 Full Size CLI - Manual (Page 262)

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 22
Format
snmptrap mode <name> <ipaddr>
Mode Global Config
6.6.18.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able
to receive traps).
Format
no snmptrap mode <name> <ipaddr>
Mode Global Config
6.6.19 snmp trap link-status
This command enables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
“snmp-server enable traps linkmode” on page 6 - 20.
Format
snmp trap link-status
Mode Interface Config
6.6.19.1 no snmp trap link-status
This command disables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20).
Format
no snmp trap link-status
Mode Interface Config
6.6.20 snmp trap link-status all
This command enables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20
Format
snmp trap link-status all
Mode Global Config
6.6.20.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20
Format
no snmp trap link-status all
Mode Global Config
6.6.21 show snmpbind
This command displays the port the SNMP server is binded to.