3 console redirection (vt100 mode), 1 requirements, 2 ansi and vt100 keystroke mapping – Kontron AT8060 User Manual
Page 123: 3 vt-utf8 keystroke mapping, Requirements, Ansi and vt100 keystroke mapping, Vt-utf8 keystroke mapping
Software Setup
108
www.kontron.com
5.3
Console Redirection (VT100 Mode)
The VT100 operating mode allows remote setup of the board. This configuration requires a remote terminal
that must be connected to the board through a serial communication link.
5.3.1
Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal emulation programs such as Putty,
Telix©, HyperTherminal(Windows), minicom(Linux) or ProComm©(Windows) can also be used.
5.3.2
ANSI and VT100 Keystroke Mapping
5.3.3
VT-UTF8 Keystroke Mapping
The following "escape sequences" are defined in the "Conventions for Keys Not in VT100 Terminal Definition
and ASCII Character Set" section of "Standardizing Out-of-Band Management Console Output and Terminal
Emulation (VT-UTF8 and VT100+)",available for download at microsoft.com.
Up
<ESC>[A
Down
<ESC>[B
Right
<ESC>[C
Left
<ESC>[D
Home
<ESC>[H
End
<ESC>[K
F1
<ESC>OP
F2
<ESC>OQ
F3
<ESC>OR
F4
<ESC>OT
F1 Key
<ESC>1
F2 Key
<ESC>2
F3 Key
<ESC>3
F4 Key
<ESC>4
F5 Key
<ESC>5
F6 Key
<ESC>6
F7 Key
<ESC>7
F8 Key
<ESC>8
F9 Key
<ESC>9
F10 Key
<ESC>0