Kontron KTAM3874-pITX - Manual (Page 13)

KTD-S0057-I Page 9 U-Boot Setup
KTAM3874/pITX Software Guide
2.7 Save Command
This is one of the most important sub-commands. Without this calling all Setup changes are lost after
power off. The save instruction writes the temporary Setup settings into the non-volatile memory device
(EEPROM).
Syntax:
setup save <Enter>
2.8 Summary Command
This Setup command gives a quick overview about all actual settings.
Syntax:
setup summary <Enter>
Example:
DISPLAY PART:
First boot display : hdmi
Second boot display : lcd
Boot display mirror mode : enabled
LCD panel resolution : sxga
LCD panel mapping : ldi
Backlight output control : pwm
Backlight enable level : high
Backlight brightness : 255
DEVICES PART:
mPCI Express interface : enabled
Audio interface : disabled
LAN interfaces : enabled
SATA interface : disabled
CAN interface 0 : enabled
CAN interface 1 : enabled
UART interface 5 : rs485
GPIO/TIMER4+6 interface : gpio
GPIO/TIMER5+7 interface : gpio
GPIO/UART2 interface : uart
GPIO/UART4 interface : gpio
GPIO/SPI3 interface : gpio
2.9 ShowDID Command
The showdid command provides the necessary information for checking the DisplayID TM values. Some addi-
tional messages are possible, for example:
No DisplayID record present !
ATTENTION: DisplayID record is not activated !
Syntax: setup showdid <Enter>