Kontron KTAM3874-pITX - Manual (Page 43)

KTD-S0057-I Page 39 Linux® Programming Examples (DebianTM)
KTAM3874/pITX Software Guide
10.2.2 SPI TM Display Interface
The SPI TM interface is well suited to connect uncomplicated intelligent small graphic modules for example
Electronic Assembly eDIP128-6.
The schematic below shows the connection to I/O connector J2105 pin 5 to 8 (SPI2). Please notice that this
draft only serves for demonstration purposes but not for real applications.
In general the following pinout applies for all SPI TM interfaces:
D0 $ MISO (Master In Slave Out = Receive)
D1 $ MOSI (Master Out Slave In = Transmit)
Note: Please perform a RESET before you execute the test program.