Kontron KISS 2U Short KTQ67 - Manual (Page 19)

7. Product Description KISS 2U Short V2 – User’s Guide (V1.00)
7.1.2. Power LED and HDD Activity LED
The LED indicators (see Fig. 11, pos. 5 and Fig. 13) of the KISS 2U Short V2 platform are located on the front side, behind
the front access panel.
2 HDD activity LED
1 Power LED
2
1
Fig. 13: Indicators on the front side
Power LED
(green) This LED (Fig. 13, pos. 1) lights up green when the system is turned on by the power button.
Prerequisite:
The system must be connected to the AC power source, using the power cable. The power supply
ON/OFF switch on the rear of the system must be set to “
ON“.
HDD LED
(orange) This LED (Fig. 13, pos. 2) lights up during hard disk activity.
Do not press the eject button, while the drive LED is lit or is flashing.
7.1.3. USB Interfaces
KISS 2U Short V2 is equipped with two USB (2.0) interfaces (see Fig. 11, pos. 10 and Fig. 14) at the front side. These
connectors allow you to connect different USB devices to the KISS 2U Short V2 platform.
Fig. 14: USB interfaces on the front side
7.1.4. Front Access Panel
The securing lock mechanism (Fig. 9, pos. 4) located at the front access panel allows you to protect your system from
unauthorized use. When the access panel is locked, the cover of the KISS 2U Short V2 system can not be removed, and the
drives, filter mat holder and power button are not accessible.
The key should be kept somewhere where it is not accessible to unauthorized persons.
If USB devices are connected to the USB ports (Fig. 11, pos. 10 and Fig. 14) on the front of the device,
the front access panel cannot be closed and locked.
www.kontron.com 17