Kontron KISS 2U Short KTQ67 - Manual (Page 20)

7. Product Description KISS 2U Short V2 – User’s Guide (V1.00)
7.1.5. Cover Fastening Screw on the Front Side
The cover fastening screw (Fig. 11, pos. 6) secures the cover to the chassis on the front side.
To remove the cover of the KISS 2U Short V2 platform, the following knurled screws have to be unscrewed:
❏ the cover fastening screw (Fig. 11, pos. 6) and Fig. 25) on the front side
❏ the knurled screws (Fig. 15, pos. 6, Fig. 16, pos. 8 and Fig. 26) on the rear side
To close the chassis of the KISS 2U Short V2 platform properly, the cover has to be attached and the
abovementioned screws have to be fastened.
7.1.6. Filter Mat and Filter Mat Holder
The filter mat and the filter mat holder (Fig. 11, pos. 3) are located behind the air grilles (Fig. 9, pos. 3) of the front
access panel. The filter mat holder (Fig. 42, pos. 4) is mounted to the fan slide-in module (Fig. 41, Fig. 11, pos. 2) via a
knurled screw (Fig. 42, pos. 5) and two centring latches (Fig. 42, pos. 6). A filter mat (Fig. 44) is inserted in the filter mat
holder (Fig. 43). This filter mat protects your system against dust and dirt (see section 10.2 “Cleaning the Filter Mat”).
7.1.7. Steel Mesh Guard (for IP52 Variant only)
The KISS 2U Short V2 platform variant with IP52 protection class provides (for indoor use) protection against dust and
moisture. If you have ordered a KISS 2U Short V2 platform with IP52 Protection Class, the filter mat holder (Fig. 45) is
fitted with an additional steel mesh guard (Fig. 46). Please observe the subsection 10.2.1 “Cleaning Steel Mesh Guard (for
IP52 Protection Class only)”.
The frontal IP52 protection class for the KISS 2U Short V2 platform is only ensured with the additionally
inserted steel mesh guard and with closed front access panel.
7.1.8. Fan Slide-in Module
The two system fans are integrated in a user-friendly, replaceable fan slide-in module (hot-swap) (see subsection 7.2.5
“Fan Slide-In Module and Temperature Sensor”). The fan slide-in module (Fig. 11, pos. 2 and Fig. 36) can be replaced
during operation (see section 10.1 “Replacing System Fans”).
7.1.9. Drive Bays
Depending on the ordered system configuration, your KISS 2U Short V2 can be equipped with up to two drive bays (see
(Fig. 11, pos. 8 and 9; configuration with an internal HDD):
Drive Bay Description (refer to Fig. 11)
L1
❏ one externally accessible 5.25" drive bay (shown with a installed DVD drive)
L2
❏ one internal 3.5" drive bay for a SATA HDD (shown with a not externally accessible HDD)
or
❏ a front accessible 5.25" slim-line drive bay
or
❏ a CF Reader
18 www.kontron.com