Kontron KISS 2U Short KTQ67 - Manual (Page 34)

9. Starting Up KISS 2U Short V2 – User’s Guide (V1.00)
9.
Starting Up
Please consider the Hints included in the chapter 4 “General Safety Instructions for IT Equipment”.
When used as intended the KISS 2U Short V2 platform is to operate only closed and locked.
Only when the cover is properly installed, secured with the knurled screws on the rear and the cover
fastening screw on the front, and the access panel is locked with the key, it is ensured that the user
doesn’t have access to the internal parts of the KISS 2U Short V2 platform, loaded with hazardous energy.
The rated voltage range of the mains (AC) must agree with the voltage value on the type label.
9.1. AC Power Connection
The AC mains input socket is located on the rear side of the KISS 2U Short V2.
Caution!
Even you turn off the system using the power button (Fig. 11, pos. 7) there is still a standby-voltage of
5 VSb on the motherboard.
The unit is completely disconnected from the mains, only when the power cord is disconnected either
from the mains or the unit. Therefore, the power cord and its connectors must always remain easily
accessible.
The outlet of the AC power source must be located near to the device and be easily accessible.
Please observe the settings for the option “Restore on AC Power Loss” in BIOS Setup. The standard
configurations of KISS 2U Short V2 platform are delivered with the BIOS default settings.
ON/OFF Switch
of the PSU
Fig. 33: KISS 2U Short V2 - AC connection AC power plug
To connect the KISS 2U Short V2 to power, proceed as follows:
1. The KISS 2U Short V2 systems with grounding studs marked with a PE symbol have to be grounded by establishing a
large-area contact between the grounding stud and an appropriate grounding connection point (refer to the
subsection 7.2.4 “Grounding Stud”, Fig. 19 and Fig. 20).
2. Connect the AC power cord to the AC input connector.
3. Connect the other end of the AC power cord to a corresponding mains outlet.
Use a power cord suitable for the mains power supply in your country.
Make sure that the mains power supply (power outlet) is properly grounded and that the power cord is
in perfect condition without any visible damage. An ungrounded power supply is not permissible.
32 www.kontron.com