Kontron KISS 2U Short KTQ67 - Manual (Page 37)

10. Maintenance and Prevention KISS 2U Short V2 – User’s Guide (V1.00)
1 2 1 3 4
Fig. 36: Fan slide-in module without filtermat holder Fig. 37:Rear view of the fan slide-in module
Fig. 38: Fan slide-in module with mounted filter mat holder Fig. 39: Side view of the fan slide-in module
Legend for Fig. 36 and Fig. 37:
1 Fan slide-in module with two knurled screws
2 Bolt with tapped hole for mounting the filter mat
holder
3 Socket for fan power supply and control
4 2x fans (temperature controlled
independently from each other)
5. Replace the fan slide-in module with a new functional module.
6.
Insert the retained filter mat holder (with filter mat) to the front side of the fan slide-in module as described in the
section 10.2 “Cleaning the Filter Mat” (step 7 and step 8).
7. Slide the fan slide-in module with mounted filter mat holder (Fig. 38) into the fan compartment (Fig. 35, pos. 4).
8. Push the fan slide-in module into the fan compartment until the fan control connector (Fig. 37, pos. 2) is firmly
inserted into the socket (Fig. 35, pos. 3).
9.
Fasten the knurled screws of the fan slide-in module (Fig. 34, pos. 1)
www.kontron.com 35