Kontron M2M Smart Services Developer Kit User Manual - Manual (Page 27)

27
5 Drop-In PCI Express Mini Card 3G Module
Installation
5.1 3G- Enabled SKUs of the M2M System
Selected SKUs come with a pre-certified 3G module. This option makes it easier for development, testing and
deployment in with some operators. A SIM card must be obtained from your local 3G provider.
5.2 Addition/Replacement
If you purchased a Kontron M2M Smart Services Developer Kit that does not include the 3G module, the Ericsson
F5521gw module may be added to the system since drivers are enabled and the BIOS supports this module. Please
note that adding any other module will require additional drivers and certifications for the system.
5.3 Before You Begin
Warning: Electrostatic discharge (ESD) and ESD protection: ESD can damage modems, boards, and other parts. We
recommend that you perform all procedures in this chapter only at an ESD workstation. If one is not available, provide
some ESD protection by wearing an antistatic wrist strap attached to chassis ground (any unpainted metal surface)
on your Kontron M2M Smart Services Developer Kit when handling parts.
Tools and Supplies Needed

#1 and #2 Phillips (cross-point) screwdrivers (or interchangeable tip screwdriver with #1 and #2 Phillips bits)

Torque screwdriver. Torque should be 1.5 inch/pound

Personal grounding device such as an anti-static wrist strap and a grounded conductive pad (not shown)

Ericsson F5521gw module
System References
All references to sides, top and bottom are defined earlier in this manual in section 2.