Removing a hard drive tray from the chassis, Attaching a hard drive to the drive tray – Kontron NSC2U IP Network Server User Manual
Page 29
Kontron IP Network Server NSC2U
December 2009
Product Guide, rev. 1.4
29
Server Component Installations and Upgrades—NSC2U Server
The IP Network Server NSC2U does not support all SAS hard drives. To see a list of
validated manufacturers and hard drive types, refer to the Tested Hardware and
Operating System List (THOL) at:
(Search for NSC2U, click on Product Downloads, and
then Compatibility Matrix.)
3.3.1.1
Removing a Hard Drive Tray from the Chassis
1. Remove the front bezel. For instructions, see
2. Select the drive bay where you want to install the drive and remove the drive tray
by pressing the green button to open the lever. (“A”)
Note:
If you will have fewer than six drives installed, drive bay 0 must be used first, then
drive bay 1, and so forth.
3. Pull the drive tray assembly out of the chassis.
3.3.1.2
Attaching a Hard Drive to the Drive Tray
1. If a drive is already installed (that is, if you are replacing the drive), remove it by
unfastening the four screws that attach it to the drive tray. (“A”)
Figure 12.
Removing a Drive Tray from the Chassis
TS000274
5
4
3
2
1
0
A