Kontron NSC2U IP Network Server - Manual (Page 65)

Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
65
Optional Component Installations—NSC2U Server
After the connection is made to the front panel, all the components that were removed
or disconnected for this installation must be replaced.
5. Replace the PCI fan assembly and connect the fan power cables using the
extensions. For instructions, see Section 5.2.5, “Installing the Fan Assembly Back
into the Chassis” on page 106 .
6. Replace the flex cable over the PCI fan assembly and the support bracket and
connect it to the SAS backplane board.
7. Install the PCI riser card assembly back into the chassis. For instructions,
see Section 4.2.5, “Replacing the Riser Card Assembly on the Server Board” on
page 55 .
8. If this is the last task you are performing, replace the processor air duct, the front
bezel, and the top cover of the chassis. Reconnect all the external devices and plug
in the power cord(s).
For information about mounting the server in a rack, see Section 3.5, “Installing
the Server into a Rack” on page 48
Figure 49. Fastening the 4xGbE Connector Assembly to the Front Panel
D A C B
B
A
TS000329