La-Z-Boy La-Z-Touch Massage System after 08/11/2014 - Manual (Page 4)

7 6
1. The power supply cable and hand wand are secured to the body bracket (F IGURE 1).
Carefully cut the cable tie. Set the power transformer aside and lay the hand wand on the seat.
2. Lay the back across the chair arms (F IGURE 2).
3. Locate the two larger, round hand wand connectors, one extending from the bottom of the
chair back and one lying on the seat of the chair. Align the arrows on the connectors and
push together. Close the locking cover to secure the hand wand connection (F
IGURE 3).
4. Place the power transformer on the floor near the base of the chair. Route the power supply
cable that extends from the bottom of the chair back down the back of the chair between
the back of the seat and the metal rear rail. Plug the round power supply connector into the
power transformer connector (F
IGURE 4).
La-Z-Touch ® 2-Motor Massage & Heat Recliner
Assembly Instructions
F IGURE 8
Body
Bracket
Back Bracket
Back
Bracket
Locking
Lever
Locking
Position
La-Z-Touch ® 2-Motor Massage & Heat Recliner
Assembly Instructions
F IGURE 6
– Do not plug in until instructed.
NOTICE
F IGURE 4 F IGURE 3
F IGURE 1 F IGURE 2
Power Transformer
Hand Wand
Connector
Make this
connection
Hand Wand Cable
Power Supply
Cable
Make this
connection
(Assembly Instructions Continued)
F IGURE 5
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
5. Turn the locking levers, located on the brackets attached to the back (one on each side),
to a 90 degree angle (F IGURE 5).
6. Install the back.
• Lift the back at a slight angle and align the brackets on the back with the brackets on the body.
Lower the back onto the body, making sure the back and body brackets are completely engaged.
(F
IGURE 6). Do not allow the cables to become pinched.
- To make sure the back is properly installed, with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position, the brackets are not engaged (F
IGURE 7). Remove the back and
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F IGURE 8).
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
(Assembly Instructions Continued)
F IGURE 7