La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 10)

Luxury-Lift ® Power Recliner
Troubleshooting
1LF Luxury-Lift ® Power Recliner
Operating Instructions
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Do not use unit if the hand wand
has been dropped in water or any liquid. Contact your La-Z-Boy ® dealer for service.
WARNING
1LF Lift Chair does not have heat or massage features. – To reduce the risk of injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy ® dealer for service.
WARNING
19 18
Press and hold the toggle
lever UP to raise the chair.
Press and hold the toggle
lever UP to return to the
seated position from the
reclined position.
Press and hold the toggle
lever DOWN to lower the
chair to the seated position.
Press and hold the toggle
lever DOWN to raise the
legrest and recline the
chair back.
Troubleshooting for Luxury-Lift ® Power Recliners
The lift chairs are equipped with built-in amperage overload protection. This feature prevents damage
to the motors and electronics if there is an overload, by stopping the operation of the motors.
If the amperage overload protector trips and shuts down the motors:
1. Release the UP or DOWN toggle switch. The system should reset automatically.
If the amperage overload protector trips repeatedly, check the following:
1. Make sure the cable tie, used to secure the lift base during shipping, has been removed.
2. Make sure the operating capacity has not been exceeded and there is only one occupant in the chair.
3. Make sure there is nothing interfering with the movement of the chair.
If the lift recliner does not work, check the following:
1. Make sure the Power Transformer is plugged into an electrical outlet.
2. Make sure the electrical outlet is working. For example, make sure there are
no blown fuses or tripped circuit breakers.
3. Make sure all the connectors are secure; refer to the Assembly Instructions.
4. Make sure the electrical cords are not crimped or pinched. Make sure
the electric cord or plug is not damaged.
5. Make sure the operating capacity has not been exceeded and there is only one occupant
in the chair; refer to the Operating Instructions.
If the amperage overload protection continues to trip, or if the lift recliner still does not operate
properly, contact your dealer for instructions on returning the chair for examination and repair. Except
for replacement of the Power Transformer, never attempt to make any repairs or adjustments yourself.
Power Transformer Replacement
If the Power Transformer must be replaced:
1. Unplug the Power Transformer from the electrical outlet.
2. Disconnect the power transformer from the connector behind the chair;
refer to the Assembly Instructions.
3. Align the clips on the power transformer connector and the connector behind the chair,
and push the connectors together until they lock; refer to the Assembly Instructions.
(Troubleshooting Continued)