La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 7)

Luxury-Lift ® Power Recliner
Battery Backup Assembly Instructions
F IGURE 2 F IGURE 1
Phillips
Head Screw Power
Transformer Battery
Cover (2) 9-volt
Alkaline
Batteries Battery
Cover
13 12
– To reduce the risk of serious injury:
• In the event of a power failure, the battery backup provided may not lift the user to a fully
raised position. To ensure lift functionality during a power outage, a battery backup system
must be purchased separately. Contact your La-Z-Boy
® dealer for more information.
Replace the power transformer batteries every six months and after each power
failure use.
WARNING
Battery Backup Assembly Instructions
The performance of the built-in battery backup cannot be guaranteed in the mevent of a power failure.
If you require continuing use during a power outage, you should purchase a separate battery backup
system. Contact your La-Z-Boy
® dealer for more information.
The Battery Backup is located in the Power Transformer and uses two 9-volt alkaline batteries
(not included).
1. Unplug the Power Transformer from the electrical outlet and disconnect the Power Transformer
connection at the base of the chair.
2. Remove the Phillips head screw from the battery cover on top of the power transformer (F IGURE 1).
3. Place the connection caps over the battery terminals on each battery. Place the batteries in the
Power Transformer (F IGURE 2).
4. Place the battery cover over the batteries and secure with the Phillips head screw removed
in Step 2 (F IGURE 1).
5. Proceed to the Operating Instructions.
Luxury-Lift ® Power Recliner Transformer Specifications:
Input: AC120V 60Hz 5AT
Output: DC 9.6V 0.3A – DC 29.5V 1.7A
Luxury-Lift ® Power Recliner
Operating Instructions
– To reduce the risk of serious injury or death:
• Do not let children play on or near the chair when in use. Serious injury or death could
occur if head or body parts are under the chair arms when the chair is moved from the
full lift to the seated position.
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
DANGER
The automatic homing feature returns the lift chair to the seated position after the power is
restored following a power interruption. This feature may cause the lift chair to move slightly
when plugged in. Connect the Power Transformer connector to the connector at the base of the
lift chair. Plug the power transformer directly into a wall outlet.
Luxury-Lift ® Power Recliner Operation
Remove the hand wand from the outside arm pocket.
• To use the power assistance feature to sit in the chair, stand beside the chair and press
the toggle lever toward the UP position on the hand wand. Release the toggle lever when
the chair reaches a comfortable height to sit against, depending on your personal needs
and preference. Step back into the chair and sit in the center of the seat while keeping
your feet firmly on the floor. Press the toggle lever toward the DOWN position on the hand
wand to lower the chair. Release the toggle lever when you reach the seated position.
• The legrest extension is separate from the back recline, allowing you to raise the legrest without
reclining the back. To extend the legrest, press the toggle lever toward the DOWN position on the
hand wand. Release the toggle lever when the legrest reaches a comfortable height.
• To recline the back, press the toggle lever toward the DOWN position on the hand wand. Release the
toggle lever when you reach the desired recline position.
• To return the back to the upright position from the recline position, press the toggle lever toward the
UP position on the hand wand. Release the toggle lever when the back is upright.
• To lower the legrest, press the toggle lever toward the UP position on the hand wand. Release the
toggle lever when you reach the seated position.
• To use the power assistance feature to exit the chair, firmly position your feet to maintain balance
and prevent sliding or falling. Press the toggle lever toward the UP position to raise the chair, to stop
movement of the chair release the toggle lever. When the chair reaches a height that enables you to
comfortably stand, release the toggle lever and carefully exit the chair.
– To reduce the risk of serious injury:
• The 1HL/1ML lift chairs are intended for a single occupant, not exceeding 500 pounds.
Do not operate the chair with more than one occupant in or on any part of the chair.
• The 1LF lift chairs are intended for a single occupant, not exceeding 300 pounds.
Do not operate the chair with more than one occupant in or on any part of the chair.
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the back
of the unit. Move the unit into or out of the reclining position slowly, making sure that
no children or pets are in close proximity.
WARNING
(Operating Instructions Continued)