La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 9)

1HL Luxury-Lift ® Power Recliner
Heat Operating Instructions
17 16
1HL Luxury-Lift ® Power Recliner
Heat Operating Instructions
1HL Lift Chair Heat Functions and Automatic Timer Operation (1HL hand wand image is shown
on page 17.)
The heat system has an automatic timer that will shut off the HEAT functions after approximately
15* minutes of operation.
• Pressing the HEAT BACK will start the heat in the lumbar area.
• Press the HEAT BACK button once for low heat, indicated by a green LED.
• Press the HEAT BACK button twice for high heat, indicated by a red LED.
• Pressing the HEAT SEAT button will start the heat in the upper thigh area.
• Press the HEAT SEAT button once for low heat, indicated by a green LED.
• Press the HEAT SEAT button twice for high heat, indicated by a red LED.
• To turn off the heat functions, press the heat buttons that are activated. The function is off when
the LED is off.
• The heat cycle will temporarily stop when using the UP or DOWN function, but will resume when
the UP or DOWN function is complete.
* The control unit features overheating protection. The heat functions will run for up to two 15 minute
cycles. After two continuous cycles the heat will shut down. The hand wand display will show HOT for
15 seconds if another heat cycle is attempted prior to the cool down period. There is no danger of
burns or fire.
Allowing the system to cool down for 7½ minutes will provide one 15 minute heat cycle.
Allowing the system to cool down for 15 minutes, will provide two 15 minute heat cycles.
(Operating Instructions Continued)
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Do not use unit if the hand wand
has been dropped in water or any liquid. Contact your La-Z-Boy ® dealer for service.
WARNING
Press and hold the toggle
lever UP to raise the chair.
Press and hold the toggle
lever UP to return to the
seated position from the
reclined position.
Press button once to activate
low heat (green LED) in the
upper thigh area.
Press button twice to activate
high heat (red LED) in the
upper thigh area.
Press and hold the toggle
lever DOWN to lower the
chair to the seated position.
Press and hold the toggle
lever DOWN to raise the
legrest and recline the
chair back.
Press button once to activate
low heat (green LED) in the
lumbar area.
Press button twice to activate
high heat (red LED) in the
lumbar area.