Losi LOSB0113 - Manual (Page 4)

4
PEAk DETECTION CHARGER
NiMH battery peak detection chargers monitor the battery during
charging and automatically shut off upon full charge. You can either
purchase a peak detection charger that plugs into a household AC wall
socket or one that requires you to also purchase a 12V power supply.
If you are using a charger other than a peak detection charger, make
sure your battery is fully discharged prior to charging. Many of these
have a 15–20 minute timer that allows you to set a charge time. If the
battery is not fully discharged, you can potentially over-charge your
battery pack.
Do not charge any battery unattended, and monitor
for heat build up. If the battery pack is more than warm to the touch,
immediately discontinue charging. Read all safety precautions
supplied by the charger and battery manufacturer.
WARNING: NEVER use an NiMH battery charger to charge a LiPo
battery pack.
SUPPLIED AND REQUIRED EQUIPMENT
Supplied tools
• 2-Way wrench • Flat Turnbuckle Wrench
• 4 Hex Wrench “L” shaped
- .050, 1/16, 5/64, and 3/32
Recommended Accessories
• Hobby grade knife • Needle nose pliers
• Side cutting pliers • Safety goggles
• Soldering iron • Double-sided tape (LOSA4004)
• CA glue (LOSA7880 or LOSA7881)
Required Equipment
• 540-sized motor • Electronic speed control
• 2S LiPo battery pack & charger • 1/10 steering servo
• 2-channel radio system
• Polycarbonate paint